6-Port Ethernet Single Chip Switch Controller with MII/RMII Interface

The DM8606C is a fully integrated and cost-effective fast Ethernet switch controller with five 10/100MB PHY and six 10/100MB MAC with MII/RevMII/RMII. The controller provides basic Layer-2 switch functions and advance IEEE 802.1Q VLAN, priority queuing scheme, IGMP snooping protocol. Spanning Tree protocol, The integrated 5 ports PHY are compliant with IEEE 802.3u standards. The MII/RMII/Reverse MII interface provides the flexibility to connect Ethernet 10/100MB PHY devices.

Features
- Ethernet Switch with five10/100Mb PHY, six 10/100Mb MAC wit MII/RevMII/RMII.
- Per port supports 4 priority queues , Port-based, 802.1P VLAN, MAC based,
   IPv4 TOS, IPv6 DSCP.
- Support 802.1Q/port-based VLAN up-to 16 VLAN group with full 12-bit VID: tag/untag,
  priority remarking.
- Per port support bandwidth, ingress and egress rate control.
- Support Broadcast Storming filter function
- Support Store and Forward switching approach
- Support IEEE 802.3x Flow Control in Full-duplex mode.
- Support Back Pressure Flow Control in Half-duplex mode.
- Recode up-to 2K Uni/Multi-cast MAC addresses
- Support hardware IGMP v1,v2/MLD v1snooping
- Automatic aging scheme
- EEPROM interface for power up configurations
- Support MIB counter
- Support multicast filter function
- Support STP
- Support serial LED in 3-MII mode
- Register access by MDC/MDIO format
- Support trunk ports
- DSP PHY with Auto-MDIX
- Built in linear regulator control register

The DM8606C ist not recommended for new designs.

Additional Documents:

DM8606C Datasheet
Application Note DM8606C M3 and DM8806
Design Hint Connection RJ45 - Center Tabs to PHY
General Layout Guide
Two DM8606C Circuit Diagram

RoHs and further information:
RoHs Compliance Information
Recommended Soldering
Customs clearance number: 85423190 according to
Liste vom Statistischen Bundesamt valid from 01.01.2007